#410 QUICK DRY PRIMER

• Solvent-Based, Low VOC Fast-Drying, Penetrating and Bonding Sealer
• Primes Most Surfaces Prior to Application of Cold Applied or Hot Mopped Asphalt Coatings, Roof Cements, and Adhesives

Surface must be clean and dry, free of moisture both on and beneath the surface. Scrape off gravel to provide a smooth surface. Sweep roof thoroughly to remove as much dust, dirt, and debris aspossible. Use wire brush to remove rust and scale from metal.

Apply a thin, single coat of #410 over the entire surface with a roofing brush or heavy-duty spray equipment. Brush out any excess immediately after application. Avoid over-application and buildup of surface film. Allow to dry thoroughly before applying adhesives or coatings. Store primer in a warm room overnight before using in cold weather. Drying time varies with weather conditions. DO NOT HEAT CONTAINER. DO NOT THIN

Application range is between .5 - 1 gallon per 100 square feet depending on surface porosity

Clean tools with mineral spirits or paint thinner.

DO NOT ALLOW TO FREEZE. DO NOT THIN. DO NOT HEAT CONTAINER or store at temperatures greater than 120°F. Be sure the lid is tight and the pail is secured when transporting this product. Do not allow pail to tumble as this may loosen the lid and allow leakage or spillage to occur. DO NOT USE with solvent sensitive insulation, wood shingles or wood flashings. This coating is not recommended over PVC sheet roofing, rubber, gravel, shingles of any kind, or old roofs that are too dry and brittle.

D.O.T. Classification: Roof Coating, Not Regulated NFMC #170080