#302 RUBBER COAT ASPHALT EMULSION

For best results surfaces must be cleaned, dried, and free of moisture on and beneath the surface. All surfaces must be clean and free from dirt, grease, oil, loose granule, peeling paint, rust, excess chalk, and other foreign matter, which could prevent proper adhesion. This is best accomplished using a high pressure wash of at least 2,000 psi. A surface cleaner shall be used to remove all grease or oily deposits. Rusted metal should be cleaned with a wire brush.

#302 Rubber Coat Asphalt Emulsiont is a water-based, environmentally safe alternative to conventional hot applied, solvent-based and sheet membrane waterproofing systems. #302 cures by evaporation so a minimum ambient application temperature of 40°F (4.5°C) is required. Apply in thin coats. The product cures within 24-48 hours at 70°F (21°C) and 50% relative humidity, at a thickness of 40 wet mils (1mm). For best results, surfaces must be dry and free of dirt, debris, oil or grease. Application is not recommended if rain is imminent, or in high humidity conditions. #302 is applied at 1 gallon per 25 square feet to produce 64 wet mil / 28 dry mil protective membrane. #302 dries to touch within minutes at 70°F (21°C). Curing time will vary based on temperature and humidity

Clean tools with #652 UltraGreen Roof Wash All Purpose Cleaner or soap and warm water.

KEEP CONTAINERS TIGHTLY CLOSED WHEN NOT IN USE. KEEP FROM FREEZING. Not regulated by the Transportation of Dangerous Goods regulations. In the event of a spill, dike and contain, transfer to containers for recovery of disposal. Keep out of sewers. WASTE DISPOSAL METHOD: Follow federal, provincial, and local regulations regarding disposal.

D.O.T. Classification: Roof Coating, Not Regulated NFMC #170080